AMWYFJZF tempered glass for Samsung Galaxy A56
What this protector declares, which devices it fits, and what the listing does not tell you.
What the listing declares
| In the pack | 8 |
|---|---|
| Thickness | 0.33mm |
| Fitting frame | Included |
| Oleophobic coating | Stated |
| Fingerprint reader | Not stated |
| Case-friendly | Yes |
| Full coverage | Not stated |
| Lens protectors | Included |
Our read on it
This is a tempered glass protector listed as fitting one device, sold in 8s. Everything below is taken from the seller's own listing and from our catalogue — we have not fitted this one ourselves, and we say so rather than implying otherwise.
In its favour: an alignment frame is included, which is the single biggest predictor of a clean fit; an oleophobic coating is declared, which is what stops the surface smearing permanently after a fortnight; there are 8 in the pack, so a botched first attempt isn't a fresh purchase.
The listing advertises 9H hardness. That figure is the pencil hardness scale and essentially every tempered glass protector claims it, so treat it as table stakes rather than a reason to choose this one.
Claims made by the seller
- FITS THE Samsung Galaxy A56 (6.7 INCH): the glass is cut for this display only, with a precise cut-out for the front camera. No alignment frame is needed: line the film up with the top cut-out and it sits inside the frame. Not compatible with Samsung Galaxy A55, Samsung Galaxy A57.
- 9H HARDNESS, HIGH TEMPERATURE TEMPERED: the glass is tempered at high temperature to a 9H surface, absorbs a 2 m drop onto a hard floor and holds together in one piece if it does break, so a knock does not turn into a cracked display.
- 8 PIECES IN ONE BOX: 4 tempered glass screen protectors plus 4 camera lens protectors. The lens pieces sit on the raised camera island, which is the part that scratches first when the phone is set down on a table; they keep the picture sharp without a blurry halo. 4 cleaning kits are included, one for each glass panel.
- 2.5D POLISHED EDGE, 2-3 MM CASE CLEARANCE: the edge is 2.5D polished and sits 2-3 mm inside the frame, so most cases fit without pushing the protector up at the corners. Installation takes about three minutes: wipe the screen, dry it, lift the dust, line up the top cut-out, then press from the center outward. Small bubbles clear within 24 hours.
- 0.33 MM THIN, 99% LIGHT TRANSMISSION: the glass keeps the brightness and color of your screen, and touch response stays the same. An oleophobic coating repels fingerprints and grease, so the screen wipes clean with one pass instead of a smeared haze.
Quoted from the Amazon listing. These are the seller's claims, not our findings.
Fits 1 device
Cross-referenced from our own catalogue not the listing title.